Lehrstuhl für Fertigungstechnologie, Universität Erlangen-Nürnberg

Dr.-Ing. Daniel Vipavc

(former employee)

Mail address: This e-mail address is being protected from spambots. You need JavaScript enabled to view it


Research Groups



    • Plettke, R.; Vipavc, D.; Grüner, M.; Hagenah, H.; Merklein, M.:
      The influence of the annealing process in the fabrication of helical needles for the suture in deep wound cavities.
      Int. J. Computer Integrated Manufacturing 27(2014)10, pp. 960-967


    • Plettke, R.; Vatter, P.; Vipavc, D.:
      Basics of process design for 3d freeform-bending.
      Steel Res. Int. (2012), pp. 307-310

    • Merklein, M.; Plettke, R.; Schneider, T.; Opel, S.; Vipavc, D.:
      Manufacturing of sheet metal components with variants using process adapted semi-finished products .
      Key Eng. Mater. 504-506(2012), pp. 1023-1028

    • Plettke, R.; Vipavc, D.; Grüner, M.; Hagenah, H.; Merklein, M.:
      Prototype Manufacturing of Helical Needles for Suture in Deep Wound Cavities.
      In: E. Ceretti, A. Fiorentino, L. Giorleo, C. Giardini (Edtr.): Proc. 1st Int.Conf. Design and Processes for medical devices PROMED, NEOS EDIZIONI srl, 2012, pp. 191-194


    • Plettke, R.; Vipavc, D.; Vatter, P.:
      Influence factors of three-roll-push-bending.
      In: Tekkaya, A. E. (Edtr.): Proc. 1st Int. Tube and Profile Bending Conf., 2011, pp. 131-135


    • Plettke, R.; Vatter, P.; Vipavc, D.; Cojutti, M.; Hagenah, H.:
      Investigation on the Process Parameters and Process Window of "Three-Roll-Push-Bending".
      In: Hinduja, S.; Li, L. (Edtrs.): Proc. 36th Matador Conf., Springer, 2010, pp. 25-28

    • Hagenah, H.; Vipavc, D.; Plettke, R.; Merklein, M.:
      Numerical Model of Tube Freeform Bending by Three-Roll-Push-Bending.
      In: Associacao Portuguesa de Mecanica Teória, Aplicada e Computacional (Edtrs.): 2nd International Conference on Engineering Optimization, 2010, published on CD

    • Hagenah, H.; Vipavc, D.; Vatter, P.; Cojutti, M.; Plettke, R.:
      Creation of the Data Base for the Process Design of the Three-Roll-Push Bending Process.
      In: Teti, R. (Edtr.): 7th CIRP Int. Conf. Intelligent Computation in Manufacturing Engineering, 2010, pp. 259-264


    • Cojutti, M.; Vipavc, D.; Hagenah, H.; Merklein, M.:
      An innovative approach for the process design for three-roll bending of plain tubular components.
      In: Angeles Gutierrez, M.; Sedlmaier, A.; Galdós, L. (Edtrs.): Proc. 1st Int. Congress on Roll Forming, 2009, pp. 133-139