Lehrstuhl für Fertigungstechnologie, Universität Erlangen-Nürnberg

Dr.-Ing. Christian Hezler

(former employee)

Mail address: This e-mail address is being protected from spambots. You need JavaScript enabled to view it



Research Groups



    • Hezler, C.; Merklein, M.; Hecht, J.; Griesbach, B.:
      Identification of Process-Based Limit Stress States Applying a Stretch-Bending-Test.
      Key Eng. Mater. 504-506(2012), pp. 47-52

    • Hezler, C.; Tsoupis, I.; Merklein, M.; Kasparbauer, M.:
      Experimental determination of stress limit curves - comparison of applied technological tests and stamped components by fractographic examinations.
      In: Hora, P. (Edtr.): Proc. 5th Forming Technology Forum, Institute of Virtual Manufacturing, ETH Zurich, 2012, pp. 87-92

    • Hezler, C.; Kaupper, M.; Merklein, M.; Kasparbauer, M.:
      Investigation of influencing parameters on the shape of experimentally determined stress limit curves.
      In: Tewari, A; Narasimhan, K.; Date, P. (Edtrs.): Proceedings IDDRG2012, Indian Institute of Technology Bombay, 2012, pp. 566-573


    • Kopp, C.; Griesbach, B.; Bader, K.-M.; Freudenberg, P.; Hezler, C.; Russ, F.:
      Optimization on Hot-Forming Technologies - New Tool Designs and Alternative Heating Technologies for Tailored Properties.
      In: Kollek, R. (Edtr.): Proceedings Tools and Forming, Verlag der TU Graz, 2011, pp. 181-189

    • Hezler, C.; Kopp, C.; Bader, M.; Griesbach, B.; Merklein, M.; Russ, F.:
      Characterisation of the transition area at partial hot stamped car body components by the 3-point bending test.
      In: Wieland, H. (Edtr.): Proceedings SCT2011, Verlag Stahleisen GmbH, 2011, pp. 280-287


    • Merklein, M.; Hezler, C.; Kopp, C.; Hecht, J.; Schaller, L.:
      Kennwertermittlung für Streck-Biege-Beanspruchungen.
      In: M. Pohl (Edtr.): Proceedings Tagung Werkstoffprüfung, Stahleisen GmbH, 2010, pp. 253-258


    • Kopp, C.; Schaller, L.; Jessen, B.; Merklein, M.; Hezler, C.:
      Charakterisierung des Formänderungsvermögens von hoch- und höchstfesten Karosseriestählen mit dem 3-Punkt Biegeversuch - Einfluss der Probenpräparation.
      In: Borsutzki, M.; Geisler, S. (Edtrs.): Tagungsband Werkstoffprüfung 2009, Stahleisen GmbH, 2009, pp. 87-92