Lehrstuhl für Fertigungstechnologie, Universität Erlangen-Nürnberg



Dr.-Ing. Dipl.-Inf. (FH) Peter Vatter

(former employee)

Mail address: This e-mail address is being protected from spambots. You need JavaScript enabled to view it


Projects


Research Groups


Publications

    2014

    • Plettke, R.; Vatter, P.:
      Comparison of new analytical an numerical approaches to model the three-roll-push-bending process.
      Int. J. Mechatronics and Manufacturing Systems 7(2014)4/5/6, pp. 279-295

    2013

    • Vatter, P.; Plettke, R.:
      Process model for the design of bent 3-dimensional free-form geometries for the three-roll-push-bending process.
      Procedia CIRP 7(2013), pp. 240-245

    • Vatter, P.; Hildering, S.; Tsoupis, I.; Merklein, M.:
      Development of a damage prediction system for bending and cutting of high strength steels.
      Key Eng. Mater. 554-557(2013), pp. 2479-2486

    • Vatter, P.; Plettke, R.; Merklein, M.:
      New approaches to determine the bending contour of the 3-roll-push-bending process.
      In: Kaftanoglu, B. (Edtr.): 7th Int. Conf. on Design and Production of Machines and Dies/Molds, MATIM, 2013, pp. 71-76

    • Vatter, P.; Plettke, R.:
      Geometrical variations of tubes and their impact on freeform bending processes.
      Adv. Mater. Res. 769(2013), pp. 181-188

    2012

    • Plettke, R.; Vatter, P.; Vipavc, D.:
      Basics of process design for 3d freeform-bending.
      Steel Res. Int. (2012), pp. 307-310

    • Merklein, M.; Vatter, P.; Plettke, R.; Grüner, M.:
      Einfluss der Fließkurve auf den Rohrbiegeradius.
      Werkstattstechnik online 10(2012), pp. 689-695

    2011

    • Plettke, R.; Vipavc, D.; Vatter, P.:
      Influence factors of three-roll-push-bending.
      In: Tekkaya, A. E. (Edtr.): Proc. 1st Int. Tube and Profile Bending Conf., 2011, pp. 131-135

    2010

    • Plettke, R.; Vatter, P.; Vipavc, D.; Cojutti, M.; Hagenah, H.:
      Investigation on the Process Parameters and Process Window of "Three-Roll-Push-Bending".
      In: Hinduja, S.; Li, L. (Edtrs.): Proc. 36th Matador Conf., Springer, 2010, pp. 25-28

    • Hagenah, H.; Vipavc, D.; Vatter, P.; Cojutti, M.; Plettke, R.:
      Creation of the Data Base for the Process Design of the Three-Roll-Push Bending Process.
      In: Teti, R. (Edtr.): 7th CIRP Int. Conf. Intelligent Computation in Manufacturing Engineering, 2010, pp. 259-264